Dreamline FLEX - Page 11

“FLEX” Enclosure Rev.1, Ver.3 03/2014
11
9. Make sure the Door assembly (02) is fully extended inside the
Wall profile (01) and the Corner profile (10).
Adjust top and bottom Expanding rails to the same length. Use
a tape measure for accuracy.
See Fig. 13 for details.
10. Drill holes in top and bottom Expanding rails
through the predrilled holes using an Ø 1/8” drill
bit.
ATTENTION:
Do not drill the Expanding rail throughout,
only the first layer.
Secure the Expanding rails using Round head
screws ST4.2×10 (04) with the raised white
washers.
Cover exposed screw heads with Decorative
covers (06).
See Fig. 14 for details.
1
2
Fig. 13
Fig. 14
1
2
3
4
5
6
Ø 1/8"
Ø 1/8"