Need help?Do you have a question about the Dremel 2200 Versaflame and is the answer not in the manual?
General| Brand | Dremel |
|---|---|
| Model | 2200 Versaflame |
| Category | Flashlight |
| Language | English |
Maintain a clean, well-lit work area, free of combustible materials, and keep bystanders away.
Stay alert, use common sense, wear protective equipment, and maintain proper footing and balance.
Store the tool in a cool, dry location between 10°C and 50°C and allow it to cool down.
Always switch off and cool the tool before attaching/removing accessories or cleaning.
Warning: Extremely flammable gas under pressure; avoid sparks and open flames.
Do not puncture or incinerate gas tank; do not store above 50°C.
Keep tool out of reach of children; do not attempt to disassemble the unit.
Have tool serviced by qualified expert using identical replacement parts to maintain safety.
Sort tools, accessories, and packaging for environmentally friendly recycling.
Details on model, power, capacity, run time, heat-up, heat input, cool-down, temp, and weight.
Familiarize with components and follow steps in Figures 3 and 4 for switching on and operating.
Follow Figure 2 and refill container instructions to fill the gas tank with butane gas.
Use with an open flame is only possible if the catalyst is removed.
Adjust flame length and temperature by moving the control lever forward or backward.
Catalyst generates 680°C hot air for melting plastics and heat-sensitive materials.
Soldering tip, used on catalyst, for regular soldering activities with soldering tin.
Extension piece provides 1000°C hot air; deflector used with extension piece.
Clean tool exterior with a clean or damp cloth with neutral detergent.
Product guaranteed per regulations; normal wear, overload, improper handling not covered.
For more info on assortment, support, and hotline, visit www.dremel.com.
To Next Page
