21
Speed Settings (Continued)
* Speed for light cuts; Caution - burning on deep grooves.
• Depending on cutting direction relative to grain.
Not all speed settings can be achieved on 100 and 200 series tool. For certain applications,
a variable speed tool is required.
2 = 5,000 - 8,000 RPM's 4 = 9,000 - 15,000 RPM's
6 = 16,000 - 21,000 RPM’s 8 = 22,000 - 27,000 RPM’s 10 = 28,000 - 32,000 RPM’s
Catalog Soft Hard Laminates Steel Aluminum, Shell/ Ceramic Glass
Number Wood Wood /Plastic Brass, etc. Stone
453, 454, 455 -- - 10 ----
Chain Saw Sharpening Stones
Catalog Soft Hard Laminates Steel Aluminum, Shell/ Ceramic Glass
Number Wood Wood /Plastic Brass, etc. Stone
461, 462, 463 -- - 8 8 888
414, 422, 429 -- - 6 6 666
425, 427 -- - 8 8 - - -
423E -- - 6-8 2226-8
Polishing Accessories
Catalog Soft Hard Laminates Steel Aluminum, Shell/ Ceramic Glass
Number Wood Wood /Plastic Brass, etc. Stone
430, 431, 438 2-10 2-10 2-6 10 10 2-10 2-10 -
439, 440, 444 2-10 2-10 2-6 10 10 2-10 2-10 -
407, 408, 432 2-10 2-10 2-6 10 10 2-10 2-10 -
411, 412, 413 66 2 - 2 - - -
Sanding Bands and Discs
Catalog Soft Hard Laminates Steel Aluminum, Shell/ Ceramic Glass
Number Wood Wood /Plastic Brass, etc. Stone
409, 420, 426 -- 2-4 10 10 10 10 -
540, EZ409
543, EZ544 10 8-10 2-4 -- --
545, EZ545 8-10 8---6-8 6-8 -
560 For use on drywall. For best results, use at 30,000 rpm.
561 6-10 6-10 2-4 - 10 ---
562 -- - - - -10
EZ456 -- - 10 10 ---
EZ476 - - 2-4 -----
Cutting Accessories
Catalog Soft Hard Laminates Steel Aluminum, Shell/ Ceramic Glass
Number Wood Wood /Plastic Brass, etc. Stone
403, 404, 405 44 2-4 62 ---
428, 442, 443 44 2 4 4 - - -
530, 531, 532 -4 - 4 - - - -
535, 536, 537 44 - 4 4 4 - -
Wire Brushes
To Next Page
Loading...
