20
Speed Settings (Continued)
* Speed for light cuts; Caution - burning on deep grooves.
• Depending on cutting direction relative to grain.
Not all speed settings can be achieved on 100 and 200 series tool. For certain applications,
a variable speed tool is required.
2 = 5,000 - 8,000 RPM's 4 = 9,000 - 15,000 RPM's
6 = 16,000 - 21,000 RPM’s 8 = 22,000 - 27,000 RPM’s 10 = 28,000 - 32,000 RPM’s
Catalog Soft Hard Laminates Steel Aluminum, Shell/ Ceramic Glass
Number Wood Wood /Plastic Brass, etc. Stone
612, 640 10* 8 • -- - ---
615, 617, 618, 10* 10 • -- - ---
650, 652, 654 10* 8 • -- - ---
High Speed Router Bits
Catalog Soft Hard Laminates Steel Aluminum, Shell/ Ceramic Glass
Number Wood Wood /Plastic Brass, etc. Stone
83142, 83322, -- 6 10 4610 10
83702, 84922,
85422, 85602,
85622
Silicon Carbide Grinding Stones (blue/green)
Catalog Soft Hard Laminates Steel Aluminum, Shell/ Ceramic Glass
Number Wood Wood /Plastic Brass, etc. Stone
516 4-6 4-6 -86 ---
500 4-6 4-6 - 6-8 4-6 ---
EZ541GR -- - 6-8 4-6 ---
Abrasive Wheels/Points
Catalog Soft Hard Laminates Steel Aluminum, Shell/ Ceramic Glass
Number Wood Wood /Plastic Brass, etc. Stone
9901, 9902, 10 8410 688-10 8-10
9903, 9904,
9905, 9906,
9912
9909, 9910 8 8-10 8-10
9911
Tungsten Carbide Cutters
Catalog Soft Hard Laminates Steel Aluminum, Shell/ Ceramic Glass
Number Wood Wood /Plastic Brass, etc. Stone
541,903, 911, 10 10 -84 610 -
921, 932, 941,
945, 952, 953,
954, 971, 997,
8153, 8175,
8193, 8215
Aluminum oxide grinding stones (orange/bown)
To Next Page
Loading...
