Dremel EZ Lock EZ688-01 User Manual

EZ Lock
™
CORRECT SEATING
POSITIONNEMENT CORRECT
ASENTAMIENTO CORRECTO
CORRECT SEATING
POSITIONNEMENT CORRECT
ASENTAMIENTO CORRECTO
Read tool manual before use of this accessory. Wear eye and res-
piratory protection. Always unplug rotary tool before changing
accessories. Incorrect seating of wheel on mandrel may lead to personal injury or
property damage. Run-in for one minute before application. Do not jam, twist or pinch
wheel in workpiece or apply excessive side pressure to wheel. Always grip tool firmly with
both hands. KICKBACK may occur if wheel is jammed. Do not position your body in line
with wheel. Do not use near flammable materials or gases, fire or explosion may result.
Do not expose to water, condensation or freezing. Discard wheel if dropped, cracked or
chipped. Maximum operating speed is 35,000 RPM.
To load accessory:
PHOTO 1. Place EZ Lock mandrel (1) into collet (2) as deep as possible and tighten
collet nut (3). Note: There is a spacer (4) on the mandrel that will bottom out on the
collet nut, setting the mandrel to the correct depth.*
PHOTO 2. Pull spring-loaded sleeve (5) DOWN towards tool with one hand and hold. You
can brace the tool on the body or work-bench for extra leverage.
PHOTO 3a. With the other hand, align bowtie shape on cut-off wheel with mandrel and
make sure metal insert is facing away from the tool.
PHOTO 3b. Place wheel on the mandrel to a point just below the bowtie on the
mandrel and twist 90 degrees until the bowtie shape on the wheel aligns with the sleeve.
Release sleeve. Wheel should lock in place.
PHOTO 4a and 4b. When mounting sanding and polishing accessories, align bowtie with
!
WARNING
metal insert on bottom of accessory. To check for proper seating, hold collet lock but-
ton and twist accessory. Accessory will not be able to rotate on mandrel.
To unload accessory:
1. Pull spring-loaded sleeve DOWN toward tool with one hand.
2. Hold sleeve down while twisting accessory 90 degrees.
3. Remove accessory.
During use
Avoid damage to EZ lock mandrel by not letting it contact the workpiece.
* When using with Dremel chuck, back the mandrel out slightly before tightening.
1
4
3
2
5
1
2
4a
4b
3a
3b
90˚
90˚

Dremel EZ Lock EZ688-01 Specifications

General

Compatibility	Dremel rotary tools
Quantity	5
Maximum Speed	35, 000 RPM
Diameter	1.5 inches
Accessory Type	Cutting Wheel
Application	Cutting
Arbor Size	1/8 inch

Summary

Loading the Dremel EZ Lock Accessory

Install Mandrel and Collet

Install mandrel into collet, tighten nut, ensure spacer bottoms out on nut for correct depth.

Engage Locking Sleeve

Pull spring-loaded sleeve down towards tool and hold it to prepare for accessory attachment.

Attach Cut-Off Wheel

Align the bowtie shape of the cut-off wheel with the mandrel and twist 90 degrees to lock.

Attach Sanding and Polishing Accessories

Align bowtie with the metal insert for sanding/polishing accessories, then twist to secure.

Unloading the Dremel EZ Lock Accessory

Remove Accessory

Pull sleeve down, twist accessory 90 degrees while holding sleeve, then remove the accessory.

Safe Usage and Operation of Dremel EZ Lock

General Safety Warnings

Wear eye/respiratory protection, unplug before changes, grip tool firmly, avoid KICKBACK.

Operating Guidelines

Avoid contact with workpiece, do not jam/twist wheel, back out mandrel for Dremel chuck.