SPLASH GUARD
It is recommended to use the splash guard for all
wet cleaning applications. Keep splash guard in the
“extended” position while tool is running to contain the
spray of water and cleaning solutions.
To get into tighter spaces, the splash guard can be
retracted into the “up” position.
To remove the splash guard entirely, turn the tool off,
unscrew the backing pad, then twist the splash guard
a quarter turn to remove. Screw the backing pad back on.
WHITE FOAM ERASER PAD – PC362
Multipurpose pad recommended for use on hard
surfaces, such as countertops, glass, oors, baseboards,
doors, not painted walls, shoes, and non-stainless steel
appliances. Due to the micro-abrasive technology, the
pad will help to remove stains without using an abrasive
cleaner; however, if the surface being cleaned is not
sufciently hard, it may be nely scratched by the
material. Test small area with light pressure before use.
Not recommended for the following surfaces:
Wood with high gloss, polish, brushed, satin, Faux,
or bare; copper; stainless steel; non-stick coating or
vehicle body.
BLUE MICROFIBER NON-SCRATCH PAD – PC363
Recommended for tough jobs without scratching. Good
for use on pots and pans, grill exterior, sink, stove
top and stove grates, kitchen appliances, and outdoor
tools/equipment.
BROWN ABRASIVE HEAVY-DUTY PAD – PC361
Abrasive pad has embedded grit for jobs that require
more aggressive cleaning and removal, such as metal
prep, lawn furniture, paint removal, uncoated cookware
and more. It quickly cuts through and removes tough
stuck-on messes.
BLACK NYLON BRISTLE BRUSH – PC364
Use for tough scrubbing applications, such as: grout,
tire rims, sinks, xtures, equipment, patio furniture, and
various other surfaces in your bathroom and kitchen.
Durable polypropylene bristles are angled to allow you
to get into corners better.
STALL PROTECTION
This tool has a stall protection feature built into it to
protect the motor and battery in the event of a stall. If
you put too much pressure on the tool for too long, the
motor will stop. Simply take the tool off of the material
you were stalled on, and restart the tool with the
On / Off button. When the battery becomes close to
empty, the tool may shut down automatically more
frequent than normal. If this happens, it is time to
recharge the battery.
MAINTENANCE AND CLEANING
NO USER SERVICEABLE PARTS INSIDE.
PREVENTIVE MAINTENANCE PERFORMED BY
UNAUTHORIZED PERSONNEL MAY RESULT IN
INCORRECT CONNECTION OF INTERNAL WIRING
AND COMPONENTS WHICH COULD CAUSE SERIOUS
HAZARD.
The tool can be cleaned most effectively with
compressed dry air. Always wear safety goggles
when cleaning tools with compressed air.
!
TO AVOID ACCIDENTS, ALWAYS DISCONNECT
THE TOOL AND/OR CHARGER FROM THE
POWER SUPPLY BEFORE CLEANING
Ventilation openings and switch levers must be kept
clean and free of foreign matter. Do not attempt to clean
the tool by inserting pointed objects through an opening.
!
CERTAIN CLEANING AGENTS AND SOLVENTS
DAMAGE PLASTIC PARTS. Some of these are:
gasoline, carbon tetrachloride, chlorinated cleaning
solvents, ammonia and household detergents that
contain ammonia.
SERVICE AND WARRANTY
We recommend that all tool service be performed by
a Dremel Service Centre.
11
To Next Page
Loading...
