DRESSER Wayne 3/V390/U

Need help?

Do you have a question about the DRESSER Wayne 3/V390/U and is the answer not in the manual?

Summary

Section 1 Before You Start

1.1 Introduction

Manual describes installation of the conversion kit in a Vista dispenser.

1.2 Kit Overview and Parts List

Details the parts included in the retrofit kit and their descriptions.

1.3 Unpacking and Inspection

Steps for checking and inspecting the received kit components for damage.

1.4 Returning Damaged Components

Procedures for returning damaged parts or components to the factory.

1.5 Required Tools

Lists the necessary tools for installing the retrofit kit.

1.6 Power Ratings

Provides power rating information for dispensers equipped with the conversion kit.

Section 2 Removing Old Hardware

2.1 Introduction

Explains the process for removing old hardware before installing the conversion kit.

2.2 Removal of Old Components

Step-by-step guide to removing existing components from the dispenser.

2.3 Removal of Product Tubes and Valves

Instructions for disconnecting and removing product tubes and associated valves.

Section 3 Installing New Hardware

3.1 Introduction

Introduces the installation process for the new hardware from the conversion kit.

3.2 Installation of the New Hardware

Detailed steps for installing the new components from the conversion kit.

3.3 Testing the Installation

Procedures for testing the dispenser after the conversion kit installation is complete.

Appendix A Wiring Diagram