07-01782F F479 9 Dri-Eaz Products, Inc.
Using a Philips screwdriver, remove the pump intake
cover retention screw and the plate from the bottom of
the pump. Clean off any debris from intake area.
Replace plate when finished.
Wipe out tank with a clean rag.
Reassembly
Lower pump back into bottom of tank and fold handle down. Ensure that the pump feet are fully seated.
Replace pump retention bracket.
Push excess power cord back through cord grip and retighten cord grip. The cord should be slack, but should not
hang down and interfere with the operation of the float or the float arm assembly.
Reinstall the float ball assembly.
Replace the cover assembly.
The unit is now ready to use.
To Next Page
Loading...
