EasyManua.ls Logo

Drija Roma 76 - General Safety Precautions; Ventilation and Hot Surfaces; Cleaning and Electrical Safety; Child Safety and User Limitations

Drija Roma 76
17 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
User Manual
HORNO A GAS | ROMA 76
3
1. PRECAUTIONS FOR USE
Warning:
a) The use of a gas cooking appliance results in the production of heat and moisture
in the room in which it is installed. Ensure that the kitchen is well ventilated: keep
natural ventilation holes open or install a mechanical ventilation device
(mechanical extractor hood)
b) During use the appliances becomes hot. Care should be taken to avoid
touching heating elements inside the oven
c) Accessible parts may become hot during use. Young children should be kept
away.
d) Do not use harsh abrasive cleaners or sharp metal scrapers to clean the oven
door glass since they can scratch the surface, which may result in shattering of
the glass.
e) If the supply cord is damaged, it must be replaced by the manufacturer, its
service agent or similarly qualified persons in order to avoid a hazard.
f) The appliance is not intended for use by persons (including children) with
reduced physical, sensory or mental capabilities, or lack of experience and
knowledge, unless they have been given supervision or instruction
g) Children should be supervised to ensure that they do not play with the appliance
h) Children less than 8 years of age shall be kept away unless continuously
supervised.
i) This appliance can be used by children aged from 8 years and above and persons
with reduced physical, sensory or mental capabilities or lack of experience and
knowledge if they have been given supervision or instruction concerning use of
the appliance in a safe way and understand the hazards involved. Children shall
not play with the appliance. Cleaning and user maintenance shall not be made by
children without supervision
j) Ensure that the appliance is switched off before replacing the lamp to avoid the
possibility of electric shock.