Page 10 For technical questions, please call 1-800-444-3353. SKU 91062
continue planing slowly to the end of the
cut. Do not pull the Planer back over the
surface already cut.
4. If necessary, repeat Step #5, using
progressively deeper cuts until you near
the desired depth. Then, readjust the
Depth Knob (48) to make a light cut for
NOTE: The Planer’s Motor may stall if the
tool is improperly used. If the Motor
begins to stall, reduce the feed speed
at which you are making the cut and/or
reduce the depth of the cut.
5.
on the Trigger (16) and the Planer will
automatically stop. Wait until Planer
blade comes to a complete stop.
6. To prevent accidents, turn off the tool
and disconnect its power supply after
use. Clean, then store the tool indoors
out of children’s reach.
To Next Page
Loading...
