EasyManua.ls Logo

Drink Cup Stella - GB - Product Information and Safety; Warning - Damaged Cord;Plug; Conditions to Avoid Operation; Set-up and Installation

Drink Cup Stella
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
8 9
Warning! Never operate this appliance if it has a damaged cord or plug. If the
supply cord is damaged, it must be replaced by an approved service repre-
sentative or a similar qualified person in order to avoid any hazards.
There should always be direct access to the electrical plug after connecting
the power!
Do not use your water cooler under the following conditions:
GB
This product is not
made for DIy repair
Close to a heat
source
If the power cable
wires are frayed
or cut
When small
children may be
left unattended
If an extension
cord is needed to
reach an outlet
Where the power
cable may be
damaged
Where it may
be damaged by
chemicals
Where there is a
risk of interference
by foreign objects
If there is a risk of
liquid falling on
the unit
GB
POSITIONING
Place your Acquadrato in a convenient position with easy access to the dis-
pense panel.
Only operate your Acquadrato in an upright orientation.
When positioning your Acquadrato ensure that it is placed on a flat, level
surface.
Do not position your Acquadrato in direct sunlight.
Do not position in front of or adjacent to a radiator or other heat source.
There must be free space of at least 5cm behind the unit to allow adequate
cooling.
TRANSPORTATION
Always transport your Acquadrato water cooler in an upright orientation.
Do not transport if the WaterTrail is full or with a water bottle fitted.
CLEANING
The outer surfaces of your Acquadrato can be cleaned using a mild house-
hold detergent.
Do not solvents or abrasive cleaners.
Your Acquadrato will normally be supplied with a WaterTrail ready fitted.
Before fitting the bottle, please remove the transportation hygeinic safety cov-
ers from the bottle connection probe and the dispense nozzle.
SET-UP AND INSTALLATION
If required, load cups into the cup
dispenser in an inverted orienta-
tion.
Remove the safety label/tab from
the bottle cap and install the bottle
onto the top of the cooler - please
alow a few minutes for the internal
reservoir to fill.