Dritz 984P - Applying Decorative Cap & Stud; Applying Round Cap & Socket

984P Plastic Snap Pliers – Round, Star and Heart Instructions (cont.)
984P Plastic Snap Pliers – Flower Instructions (cont.)
Coral Cap Holder
Inserting Tool:
Insert coral cap holder into pliers.
Removing Tools:
Slip hook of gray tool remover
inside ledge of pliers and press
down to release tool.
Repeat for opposite side.
Applying Decorative Cap & Stud (Topside of garment):
1. Insert prong of decorative cap
into hole.
5. Remove brown cap holder after
applying all decorative snaps.
Metal die base will remain in
tool. Slip hook of gray tool
remover inside ledge of pliers
and press down to release tool
2. Place stud over prong. 3. Position decorative cap in
brown cap holder.
4. Squeeze pliers rmly to apply snap. Check
for tightness; if necessary, rotate pliers and
squeeze again to completely atten post.
Wrong side of fabric
2.
Wrong side
of fabric
Right side
of fabric
1.
Wrong side of fabric
3.
Wrong side
of fabric
Right side
of fabric
5.
4.
Applying Round Cap & Socket (Underside of garment):
1. Insert prong of round cap into
hole.
2. Place socket over prong. 3. Position round cap in coral cap
holder.
4. Squeeze pliers rmly to apply snap. Check
for tightness; squeeze again, if necessary.
Right side of fabric
2.
Right side
of fabric
Wrong side
of fabric
1.
Right side of fabric
3.
Right side
of fabric
Wrong side
of fabric
4.