CMS Electric Scooter Page 7 of 16 Owner’s Handbook (Code: CMS_IFU 05/18)
Tiller Adjustment
The tiller can be adjusted in to many different
positions to suit each user. To adjust follow the
steps below:
1. Hold the tiller securely with your hand (see 1
on photo) to prevent the tiller from falling.
2. Fully slacken the knob (see 2 on the photo)
so the tiller can move.
3. Using the other hand, reposition the tiller as
required then retighten the knob to secure.
Starting and Driving
1. Make sure the seat is installed properly.
2. Make sure the tiller has been secured properly
and the tiller lock is disengaged.
3. Fold down the armrests so you can rest your
arms on them.
4. Switch the key ignition on.
5. Check the battery gauge to check there is
enough power for your journey. If you have any
doubt about the remaining power, recharge the
battery pack before use.
6. Set the speed dial to a position you feel safe and
comfortable with.
7. Check the wigwag paddle and automatic brake
work correctly.
8. Before driving, check the environment around
you is safe for you to drive.
Warning
Be careful whilst driving in heavy traffic
or crowded areas. Whilst reversing the
vehicle, be aware of people or objects
behind you.
Stopping
1. Release the wigwag paddle completely. The
vehicle will automatically brake and stop.
2. Switch the scooter off at the key ignition and pull
out the key.
Stopping distance will vary with speed
so begin braking as early as possible.
Always park on flat ground, switch off
and remove the key before
dismounting.
To Next Page
Loading...