EasyManua.ls Logo

Drive Bonsai OM-812 - User Manual

Drive Bonsai OM-812
24 pages
Save Page as PDF
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
Loading...
Oxygen Conserving Device
NOTE: Healthcare Equipment Providers shallprovide
the end user withinstructions for use and
instructionsfor determining gas cylinder contents.
OM-812
PRODUCT INFORMATION AND INSTRUCTIONS
NOTE: The gauge face may be different on actual unit.

Table of Contents

Questions and Answers

  • C
    Catherine AbbottAug 5, 2025
    What to do if Drive Oxygen Equipment pulses or flows continuously?
    • D
      David GarciaAug 5, 2025
      If your Drive Oxygen Equipment is pulsing or flowing continuously, there might be several reasons. First, check if the unit is accidentally set to the “cf” (continuous flow) position; if so, turn the selector switch to the correct delivery setting. Another possible cause is that the unit wasn't set to “OFF” before you opened the cylinder valve; in this case, turn the selector switch to “OFF,” wait a few moments, and then set it to the proper delivery setting. Lastly, check for any obstructions blocking the vent hole, such as labels or a tight-fitting carrying bag. Remove any obstructions and resume use.
  • J
    Joseph RobertsonAug 18, 2025
    Why is my Drive Oxygen Equipment not pulsing?
    • S
      Scott KingAug 18, 2025
      If your Drive Oxygen Equipment isn't pulsing, several factors could be the cause. Ensure the cylinder valve is open by turning it counter-clockwise. Check the oxygen gauge to see if the cylinder is empty and replace it if needed. Inspect the oxygen cannula for any kinks or blockages; remove any kinks and clean or replace the cannula if necessary. Also, verify that the selector switch is set to the appropriate delivery setting and not in the “OFF” position.

Summary

OM-812 Product Information and Instructions

Symbol Definitions

Important Safeguards, Dangers, Warnings and Cautions

Introduction

Intended Use

Contraindications

Important Parts

Standard Product

Replacement Parts

Setting Up Your Conserver

Assembly and Use

Setup

Details the steps for connecting the Bonsai conserver to the oxygen cylinder.

Inspection Before Each Use

Explains how to examine the cylinder and regulator assembly before operating the device.

Checking for Leaks

Provides steps to identify and confirm the absence of leaks in the oxygen system.

Operating Instructions

Guides the user through the process of operating the Bonsai oxygen conserver and delivering oxygen.

Disassembly Instructions

Caring for Your Conserver

Troubleshooting

Oxygen Cylinder Duration

Information for Home and Healthcare Providers

Disinfection Between Patients

Details cleaning procedures for the device between patient uses.

Disinfection Intervals

Maintenance

Preventive Maintenance

Outlines recommended checks and procedures for maintaining the device.

Calibration

Limited Warranty

Disposal Instructions

Specifications

Technical Description

How the device functions

Explains the purpose and operational mechanism of the Bonsai oxygen conserver.

Principles of dosing, timing, triggering and settings

Details how the device delivers oxygen pulses based on breath rate and settings.

Pneumatic Diagram

Drive Bonsai OM-812 Specifications

General IconGeneral
BrandDrive
ModelBonsai OM-812
CategoryOxygen Equipment
LanguageEnglish