Table of Contents
Section 1 Introduction
1.1 General 2
1.2 Receiving 2
Section 2 Installation
2.1 Location 3
2.2 Clearances 3
2.3 Mounting Dimensions 4
2.4 Standard drive ratings 8
2.5 Common specification 10
Section 3 Wiring
3.1 Interconnection 11
3.2 Hoist interconnection diagram 12
3.3 Wire size & circuit breaker selection 13
3.4 Grounding 14
3.5 Motor thermal overload relay 15
3.6 Brake motor magnetic contactor 15
3.7 Special cautions on wiring 15
Section 4 External connection layout
4.1 Component outline 17
4.2 Function description of main circuit terminal (TM1) 19
4.3 D61530 120V isolator instructions 23
4.4 Function description of control terminal (TM2) 26
Section 5 Digital operator control
5.1 Introduction and configuration 32
5.2 Function parameter setting 35
5.3 Function code descriptions (Fn00-Fn71) 36
5.4 Factory default load 'Quick Set' 57
Section 6 Test run
6.1 Precautionary checks before test running 59
6.2 Test run 60
Section 7 Setting and adjustment
7.1 General description of settings and adjustments 61
7.2 Example of digital operator control and frequency command 62
Section 8 Fault indications 64
Section 9 Maintenance 68
Reference
a. Measurement of voltage and current 69
b. Troubleshooting procedure. 70
c. Electromagnetic compatibility (EMC) of inverter. 72
Appendix A Peripheral - Ground Fault Protection 76
Appendix B Peripheral - Digital Operator Extension 77
Appendix C - User Program List 78
Appendix D - Terminal Function List 80
Appendix E - D61530 (D61531) Input Isolator Instructions 81
Appendix F - 'B' size working schematics
i
To Next Page
Loading...