Drop Alert User Manual

DROP Alert Factory Reset
It is recommended that before performing a factory reset, that you remove the DROP Alert as a device
on any DROP system that it may be attached to. This can be done while using a local connection in
the App and going to SYSTEM > ADVANCED page. On that page, you will see “Manage Device Com-
ponents” Find the DROP Alert in that list and press the “Remove” button associated with that unit.
Once it is removed then perform the factory reset.
SYSTEM > ADVANCED > MANAGE DEVICE COMPONENTS
To reset the DROP Alert and cause it to forget any DROP network that it has been connected to, press
and hold the button while inserting the batteries. Continue to hold the button for 15 seconds. During
this time all the lights will be on solid. Once the button has been held for 15 seconds, the lights will
begin flashing once per second. At this point the Drop Alert is armed for reset, release the button and
then press it again to cause the leak detector to be reset.

Drop Alert Specifications

General

Brand	Drop
Model	Alert
Category	Measuring Instruments
Language	English