Drucker 614B - Features; Specifications

Features:
• Fixed-angle rotor for spinning 75mm, 100mm and 125mm test tubes in
specially designed tube holders
• Cool–Flow air ow design that prevents overheating of samples
• Heavy gauge steel construction for safety and durability
• Lid safety switch that prevents the centrifuge from operating unless the
lid is closed and latched
• Removable rotor for easy cleaning
• Brushless A/C motor
• Clear lid for safe observation of samples and optical calibration of speed
Page 3
Specications:
General Specications for the Model 614B Centrifuge
Nominal Speed (125mm holders): 3,150 (± 100) RPM
Nominal RCF (125mm holders): 1,200 (± 80) xg
Nominal Speed (100mm holders): 3,250 (± 100) RPM
Nominal RCF (100mm holders): 1,080 (± 80) xg
Nominal Speed (75mm holders): 3,300 (± 100) RPM
Nominal RCF (75mm holders): 950 (± 80) xg
Maximum capacity: 90 mL (6 x 15 mL)*
Overall Dimensions (H x W x D): 8.5 in. x 11 in. x 12.5 in.
Centrifuge Motor: 1/30 HP, AC
Nominal Acceleration Time: 45 seconds
Protection Breaker: 4 Amp. re–settable
Timer: mechanical, 1 to 30 minutes
accuracy ± 10%
Current Requirement: 1.0 Amps
Voltage Requirement: 115 (±10) Volts
Frequency: 60 Hz
Weight: 18.5 lbs.
Before using any cleaning or decontamination methods except those recommended
by the manufacturer, users should check with the manufacturer that the proposed
method will not damage the equipment. See page 7, (bottom), for the recommended
cleaning solutions.
Any use other than those specied by the Manufacturer is explicitly prohibited.
* Maximum sample density is 1.15 grams / mL,
(water density = 1.0 grams / mL)
WARRANTY:
The Drucker Company
warranties that this centrifuge
is free from defects in
workmanship and parts
for 12 months.
Made in the USA by
200 Shadylane • Philipsburg, PA 16866
Phone: 814-692-7661 • Fax: 814-692-7662 • www.druckercompany.com
Page 10