99
Safety
05
(b) Tilt the seat backrest to 45°, then install the
child seat.
Straighten the backrest until it contacts the
child seat's backrest.
i-Size child seats
i-Size child seats have two latches that engage on
the two rings A.
These i-Size child seats also have:
– either an upper strap that is attached to ring B,
– or a support leg that rests on the vehicle floor,
compatible with the approved i-Size seat position,
the role of which is to prevent the child seat from
tipping forward in the event of a collision.
For more information on the ISOFIX mountings,
refer to the corresponding section.
In accordance with European regulations, this
table indicates the options for installing i-Size
child seats on seats in the vehicle fitted with
ISOFIX mountings approved for i-Size.
Seat Front passenger airbag i-Size restraint system
Row 1 (a) Manually-adjustable passenger seat (b) Deactivated "OFF" i-U
Activated "ON" i-UF
Electrically-adjustable passenger seat Deactivated "OFF" Not i-Size
Activated "ON" Not i-Size
Row 2 Rear side seats i-U
Rear centre seat Not i-Size
i-U: suitable for i-Size restraint systems in the
"Universal" category, "forward facing" and
"rearward facing".
i-UF: only suitable for i-Size restraint systems
in the "Universal" category which are
"forward facing".
X: seat position not suitable for i-Size
restraint systems in the "Universal"
category.
(a) Refer to the current legislation in your
country before placing a child in this seat
position.
(b) Tilt the seat backrest to 45°, then install
the child seat.
Straighten the backrest until it contacts
the child seat's backrest.
Manual child lock
This system prevents opening of a rear door using
its interior handle.
The control, red in colour, is located on the edge of
each rear door (marked by a label).
Locking / Unlocking
To Next Page
Loading...
