DS Automobiles DS 7 CROSSBACK

144
Driving
06
When the function is activated, it is possible
that the view from above is not displayed. If
the system is activated when the vehicle has
already moved, the view from above can be fully
displayed.
Reversing camera
Rear vision
To activate the camera, located on the tailgate,
engage reverse and keep the speed of the vehicle
below 6 mph (10km/h).
The system is deactivated:
– Automatically, at speeds above approximately
6 mph (10km/h),
– Automatically, if the tailgate is opened.
– Upon changing out of reverse gear (the image
remains displayed for 7seconds).
– By pressing the white arrow in the upper-left
corner of the touch screen.
Operating limits
If the boot is heavily loaded, the vehicle may tilt,
affecting distance measurements.
Malfunction
In the event of a malfunction when
changing into reverse, this warning
lamp comes on on the instrument panel,
accompanied by an onscreen message and an
audible signal (short beep).
Contact a dealer or a qualified workshop to have
the system checked.
Reversing camera - 360
Vision
Refer to the General recommendations on the use
of driving and manoeuvring aids.
With the engine running, these systems allow
views of your vehicle’s close surroundings to be
displayed on the touch screen using one camera
for theReversing camera and two cameras for
360 Vision.
The screen is divided into two parts with a
contextual view and a view from above the vehicle
in its close surroundings.
The parking sensors supplement the information
on the view from above the vehicle.
Various contextual views may be displayed:
– Standard view.
– 180° rear view - 360° front and rear view.
– Zoom view.
AUTO mode is activated by default.
In this mode, the system chooses to display the
best view (standard or zoom).
You can change the type of view at any time
during a manoeuvre.
► Press the button in the bottom left-hand
corner of the touch screen.
► Select the type of view:
• "Standard view".
• "180° view".
• "Zoom view".
• "AUTO view".
The display is immediately updated with the type
of view selected.
The state of the function is not saved when the
ignition is switched off.
Principle of operation
Using one or two cameras, the close surroundings
of the vehicle are recorded whilst manoeuvring at
low speed.
An image from above your vehicle in its close
surroundings is reconstructed (represented
between the brackets) in real time and as the
manoeuvre progresses.
It facilitates the alignment of your vehicle when
parking and allows obstacles close to the vehicle
to be seen. It is automatically deleted if the
vehicle remains stationary for too long.
With 360 Vision, the image is created using
both cameras, when going forward and when
reversing.