DS Guitar Engineering
Chronograph User Manual v1.0.3
Revised October 31, 2016
DSGE Chronograph User Manual Page 2 of 3
Navigang the Main Menu
In order to access the main menu, simply hold the footswitch for 1 second or more while the clock is being
displayed. Release the footswitch and hold it again to advance to the next menu opon. Tap the footswitch to
select the opon that is currently displayed on the screen. Tapping the footswitch while in clock mode will have
no eect. The three opons are Clock, Countdown Timer Mode (Ctdn), and Stopwatch Mode (CtuP).
Countdown Timer Mode
Aer selecng Countdown Timer Mode the last used start me
will be displayed and the “minutes” value will blink once. Tap
the footswitch to increment the minutes value and hold the
footswitch to accept. The “seconds” value will blink once to
indicate the minutes value was accepted. Repeat the process for
the seconds value and the enre display will blink once to
indicate the mer has been set.
Tapping the footswitch at this point will have no eect on the
mer. This prevents you from inadvertently tapping the footswitch and accidentally starng the mer. Hold the
footswitch unl the mer begins to count down. The mer can be paused at any me by tapping the footswitch.
The mer can also be reset at any me by holding the footswitch. You’ll noce that your previous start me is
recalled when the mer is reset. Hold the footswitch again to exit countdown mer mode.
The display will begin to connuously ash as a warning when the mer goes below a certain threshold. By
default this value is 1 minute. Boot the Chronograph in Setup mode to change this value.
Stopwatch Mode
Aer selecng Stopwatch Mode the display should read “00:00”.
Tapping the footswitch will start, pause, and resume the
stopwatch. Holding the footswitch will reset the stopwatch.
Hold the footswitch again aer reseng it to exit Stopwatch
Mode and return to Clock Mode.
To Next Page
Loading...