DS Guitar Engineering Chronograph User Manual (English)

To Next Page

DS Guitar Engineering

Chronograph User Manual v1.0.3

Revised October 31, 2016

DSGE Chronograph User Manual Page 1 of 3

Thanks for your purchase of the Chronograph pedalboard clock! The Chronograph was purpose-designed to be

compact, versale, user friendly, and good looking to boot! If you have any suggesons for how we can improve

any of our products, feel free to contact us through our website dsguitarengineering.com or directly by email.

We genuinely hope you enjoy each purchase you make!

Overview

The Chronograph requires less than 100mA of current @ 9VDC, with a center negave power cable. This is the

same type of connecon commonly used on eects pedals. The Chronograph is fully compable with both

isolated and daisy chain style power supplies. However, we do not recommend using it with daisy chain style

supplies due to the likelihood of digital noise being coupled into your guitar signal. Do not aempt to run your

pedal at more than 9 volts DC. Aer power is applied to the DC Jack you will be greeted by the message “DSGE

Chronograph” and the current me will be displayed shortly aerwards. If you need to change the clock, the

instrucons are on page 3 under the Setup Menu secon.

Quick Start

In most cases tapping the footswitch will change or increment a parameter and holding the footswitch will

accept the parameter. The biggest excepon is the main menu. You must hold the footswitch to advance to the

next main menu opon. This prevents you from inadvertently tapping the footswitch while doing other things

on your pedalboard, which would change modes when you don’t intend to. Keep reading for detailed

instrucons on each feature the Chronograph has to oer.

Need help?

Do you have a question about the DS Guitar Engineering Chronograph and is the answer not in the manual?

DS Guitar Engineering Chronograph Specifications

General