Step 11: During the mounting process
you should have located the spot to
drill your tower bar for the 6
conductor wire (Speaker and RGB
lightning wiring) insertion. Or NOT
(see Tie-wrap solution below)
Step 12: Remove Wire NBR Plug and
Slide the wire threw the hole Snake
the wire down to the bottom of the
tower tube in a location that the
wires can be attached to the audio
(And lighting) system. Solder or butt
connect the speaker wire coming
from the tower to the speaker wire to
the system. Then heat-shrink it for
added protection from water /
moisture.
INSTALLATION
To Next Page
Loading...
Need help?
General
