DSI DS Series - Page 78

'66HULHV0RWRUL]HG*DWHV
Malfunctions
Error code Fault description Automatic reset
60 Error when initialising CAN protocol stack No
61 Error when initialising CAN bus No
62 CAN servo address fault No
63 Error download of controller parameters for the MMC-120 No
64 Reserved No
65 Error I²C-EEPROM No
66 Software fault No
70 to 7F Error when downloading the MMC-120 firmware No
Table 9: Error code
Self-resetting errors are displayed for no more than 20 seconds if
the error is no longer pending. The error code is shown, however,
as long as the error is pending.
The PRWRUL]HG JDWH is taken out of operation in case of errors
that are not self-resetting. The error code is displayed continually
until the control is taken into operation again after removal of the
error.
Toll Free 800-272-3555 | 512-321-4426 | Fax: 512-321-9181
INS-DSMG-200702
Designed Security, Inc. - 1402 Hawthorne Street, Bastrop Texas 78602
www.dsigo.com | sales@dsigo.com
78