DSI JET Series - User Manual

Questions and Answers

D
Dawn FrankAug 4, 2025
Why is the signal noisy from my DSI JET?
- D
  Douglas MurrayAug 4, 2025
  If the signal from your DSI Laboratory Equipment is noisy, it might be due to several reasons: * An ECG or RIP lead may not be properly connected to the JET device. Ensure all connections are secure. * An ECG lead may not be making good contact with the electrode. Check these connections. * The electrode might not be adhering well to the animal. Check and reattach if necessary. * The electrode could be placed over an area with excessive muscle movement; relocate it if needed. * Some electrode wires might not be attached to the animal. Connect all leads, or short the excess leads together using two patches back to back. * The BP Antenna may not be close enough to the BP implant. Move the BP Antenna closer to the implant and secure its location.
J
Jessica ChristianAug 11, 2025
How to fix no signal from the DSI JET JET device?
- R
  Rebecca DodsonAug 11, 2025
  If there is no signal from your DSI JET device, it could be due to a few reasons: * The battery may need to be recharged. Ensure the battery is fully charged. * The battery might not be correctly connected to the JET device. Verify and correct the battery connections. * The ECG or RIP leads may not be properly connected to the JET device. Check and correct these connections as needed.
J
jennifer45Aug 19, 2025
What to do if the DSI JET Laboratory Equipment JET RIP signal volume is low?
- J
  Judy DuncanSep 12, 2025
  If you're experiencing a low volume signal from the JET RIP on your DSI Laboratory Equipment, consider the following: * The RIP bands might be out of position. Check their placement and adjust if necessary. * The gain setting could be too low. Increase the gain setting on the RIP Modules. * There might be debris in the module to cable connector. Remove any debris from the connection.
Z
zbrownAug 27, 2025
Why is the signal clipped from DSI JET JET RIP?
- T
  Tammy ThompsonAug 27, 2025
  If you're getting a clipped signal from the JET RIP on your DSI Laboratory Equipment, it's likely that the gain setting is too high. Try decreasing the gain setting on the RIP Modules.