DT SWISS RATCHET EXP Maintenance

Ratchet EXP - Maintenance of the freewheel system 11
2.6 PUTTING ON THE FREEWHEEL BODY AND THE END CAPS
1. Put the freewheel body onto the hub.
2. Check if the freewheel body can be turned
and if the ratchets are engaging.
3. Grease both bearings and the inner side of
both end caps.
4. Put on the left and the right end cap.
→ The shorter end cap must be placed on
the drive side.
2.7 CHECK THE FUNCTIONALITY
1. Turn the freewheel body in both directions.
→ The freewheel body can be turned
counterclockwise easily.
The ratchets engage audibly and
perceptibly.
→ The freewheel body cannot be turned
clockwise.
2. Check the tightness of the end caps.
→ The end caps are rmly seated on the
axle and are fully pushed on.
Closing Steps: Cross reference / Note
Mount the brake rotor see manufacturer's instructions
Assembling the cassette see manufacturer's instructions
Clean the hub

DT SWISS RATCHET EXP Specifications

General

Brand	DT SWISS
Model	RATCHET EXP
Category	Switch
Language	English