13
7. Environmental protection
Please dispose according to the local laws or consult with dealer from whom you purchased it about waste disposal.
8. Manufacturer’s right
We reserve the rights to change the design of the equipment, the technique, ttings, the instruction manual and the content of the original packing
list at any time without notice. If there are some dierences between blueprint and real equipment, take the real equipment as the norm.
9. European authorized representative
10. EMC - Declaration of conformity
The device has been tested and homologated in accordance with EN 60601-1-2 for EMC. This does not guarantee in any way that this device will
not be eected by electromagnetic interference. Avoid using the device in high electromagnetic environment.
Guidance and manufacturer’s declaration - electromagnetic emissions
The models S6 LED are intended for use in the electromagnetic environment specied below. The customer or the user of the models S6 LED
should assure that it is used in such an environment.
Emissions test Compliance Electromagnetic environment - guidance
RF emissions CISPR 11 Group 1
The models S6 LED use RF energy only for its internal function. Therefore, its RF emissions
are very low and are not likely to cause any interference in nearby electronic equipment.
RF emissions CISPR11 Class B
The models S6 LED are suitable for used in domestic establishment and in establishment
directly connected to a low voltage power supply network which supplies buildings used for
domestic purposes.
Harmonic emissions lEC 61000-3-2 Class A
Voltage uctuations / icker emissions
lEC 61000-3-3
Complies
Guidance & Declaration — electromagnetic immunity
The models S6 LED are intended for use in the electromagnetic environment specied below. The customer or the user of the models S6 LED
should assure that It is used in such an environment.
Immunity test IEC 60601 test level Compliance level Electromagnetic environment - guidance
To Next Page
Loading...