A
Pm
is a range of scenes [max
48)
performed in succession.
To create/modify a program fdlow all steps listed below:
I]
If Top
48
is switched off, switch
it
on pressing
POWER
key.
21
Press
Program
key to activate the
PROGRAM
function.
[the
Program
led key will light up].
31
Press
1
+l
2
keys to select only the program that you want to modify.
[only one program
MghlrghW].
For successive program use the
Pm
key
41
Press the
UNITS
key and select through the
1
+l
2
keys the units that must
work in the program. Confirm with the
DONE
key
51
Press
Scene
key to activate the
SCENE
function.
[the
Scene
led key will light up].
61
Press one of the
1
+l
2
keys
to
select the scene that we want
to
create/modify.
For successive scenes use the
PAGE
key
71
Press the
EDIT
key to create/modify the selected scene.
8) Modify the position with the joystick and the sets of the channels with the
relative faders, press
UNIT
key for next/precedent unit.
91
When the scene has been completed,
it
can be stored through the
SAVE
key.
1
?
]
Now Top
48
is in the next scene repeat again the
7
and
8
steps.
121
When the creation of the scenes has been finished press
Program
key to
come back to the
PROGRAM
function.
[the
Program
led key will light up].
?
3)
Finally you must press the
GO
key to execute the program.
-
I
he
program is complete; to create/modify others repeat again' all the above
steps.
To Next Page
Loading...