Need help?Do you have a question about the Du Pont QuickTwist WFRO60X-1 Series and is the answer not in the manual?
General| Stages | 4 |
|---|---|
| GPD | 60 |
| Maximum Operating Temperature | 100 °F (38 °C) |
| End Cap Material | Polypropylene |
| Filtration Type | Sediment, Carbon Block, Reverse Osmosis Membrane, Post Carbon |
| Nominal Filtration Rating | 0.0001 microns |
| Maximum Operating Pressure | 100 psi |
| Diameter | 2.5 inches |
| Length | 10 inches |
| Media Material | Thin Film Composite (TFC) |
| Type | Reverse Osmosis System |
General introduction to the DuPont Reverse Osmosis Drinking Water Filtration System.
List of all components and hardware provided with the system.
List of necessary tools and materials for installation.
Contact information and resources for support and product details.
Guidance on choosing installation location and checking space requirements.
Step-by-step overview of the installation process and preparation.
Explanation of the reverse osmosis filtration process and its mechanism.
Details on contaminants reduced by the RO system, according to standards.
Critical warnings regarding filter protection, freezing, and housing replacement.
Instructions for selecting and installing the correct water fitting for the faucet adapter.
Procedure for installing the drain connector onto the sink drain pipe.
Mounting instructions for the RO filter system head assembly.
Instructions for preparing and placing the water storage tank.
Guidance on selecting the faucet mounting location and drilling requirements.
Detailed steps for attaching the faucet body, base, and spout.
Connecting 1/4" tubing from faucet adapter to system head inlet.
Connecting 3/8" tubing from system head outlet to RO faucet.
Connecting tubing for the air gap between faucet and RO system.
Connecting 3/8" tubing from system head to the water storage tank.
Setting up a remote drain point, ensuring air gap and proper tubing.
Procedure for sanitizing the RO system using bleach solution.
Checking for leaks and ensuring proper pressure build-up in the system.
Process to flush the system and prepare it for initial use.
Step-by-step guide for removing and installing QuickTwist® filters.
Detailed system specifications, performance metrics, and NSF/ANSI standards.
Guidelines for maintaining and replacing pre-filter and post-filter cartridges.
Information on RO membrane life, factors affecting it, and replacement.
Checking the operation of the check valve and automatic shut-off valve.
Common causes and solutions for low water output from the system.
Addressing issues causing low water pressure at the dispensing faucet.
Causes and solutions for high TDS levels in the filtered water.
Resolving leaks from faucet spout or connection fittings.
Identifying and resolving issues causing bad tastes or odors in the water.
Troubleshooting leaks originating from the faucet's air gap hole.
Solutions for leaks occurring at quick connect fitting points.
Information on filter types and their replacement schedule.
List of available part numbers for system components and spares.
DuPont's dedication to high-quality, effective, and environmentally friendly products.
To Next Page
