---------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------
------------------------------------
6
E N G L I S H
1 Covering hood
2 Hinge
3 Cue control
4 Pick-up arm
5 Tonearm support
6 Stylus
7 Selector lever for setting the record size SIZE
8 LIFT button for lifting (UP) and lowering (DOWN) the pick-
up arm
9 STOP button
10 START button
11 Turntable
12 Turntable axle
13 Speed selector SPEED
14 Post for storing the centering puck (for 17 cm record
singles)
15 Recording cable cinch
16 Mains cable for connection to 230 V/50 Hz
Place of installation
The device may only be installed on a horizontal, vibration-free
surface. The place of installation may not be subjected to high
temperatures, direct sunlight, moisture, dust, smoke or steam.
The device could thereby be damaged.
If TV sets or radio receivers are nearby, they should be swit-
ched off while the record player is in operation to avoid inter-
ference during operation.
If the unit is moved from a cold place to a warm place, conden-
sation may collect within the unit. The device must remain
switched off for a few hours before operation. Otherwise the
condensation can cause dangerous short circuits.
Use only cleaning agents (antistatic) intended for cleaning the
device and the turntable.These are available from your acces-
sories dealer.
Preliminary operations
Unpack the unit and all accessories. Please keep the packa-
ging for future use when transporting the device.
To Next Page
Loading...
Need help?
General
