4
LU47PW-LU47PB INSTALLATION
Placement & Mounting Speakers
The LU47 series speakers have been tested fo
r environmental usage and are weather
resistant, but not waterproof. Occasional moisture will not affect performance. The
speakers should be allowed to ventilate and dry after water exposure.
The speakers can be placed permanently outdoors for yea
r-round enjoyment. To maximize
speaker life, position in areas protected from the elements, such as the underside of eaves
and overhangs. Popular locations include decks, gazebos, porches, atriums, garages, and
covered spa areas. For temporary placement, remove the speaker from the mounting
brackets and replace the thumb screws to maintain stability if placing the speakers on end.
The LU47 series speakers have a Dual logo that can be rotated. The logo is located on the
face of the grille in the event a vertical installation is needed. The logo is spring loaded. Use
gentle force when adjusting the logo to a new orientation. To rotate the logo, elevate two
ends of the logo equally by placing your nail under and lifting lightly. While the logo is
elevated, turn the logo to the desired orientation and release.
For ease of installation, the LU47 series speakers include
an easily removable mounting
bracket. Once mounted, the bracket allows the speaker to be pivoted to its ideal location.
The included thumb screws knobs will hold the selected speaker position when properly
tightened. Avoid over tightening the knob. Before attempting the installation, carefully
evaluate the mounting surface, making sure that its composition and construction are
strong enough to support the load safely. If you are unsure about the type of mounting
hardware for your installation, consult a professional contractor or a knowledgeable
hardware store. The anchors and screws to attach the speakers are not included and must
be purchased separately. The hardened steel brackets are suitable only for attaching the
speaker to walls or ceilings constructed of solid wood, brickwork, concrete, hollow
buildings block or wood studs.
Do not mount the
bracket to
non-
reinforced plaster
sheetrock (gypsum
board). Once the bracket
is secure, reattach the
speaker using the
thumb screws included.
Mounting Your Speakers
®
To Next Page
Loading...
Need help?
General
