EasyManua.ls Logo

Dualit Jug Kettle - Safety Precautions; Important - before Using

Dualit Jug Kettle
9 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
5
This kettle is for household use only
To disconnect, turn any control to off,
then remove plug from wall outlet
Use the kettle only with the power
base supplied and vice versa
The use of accessory attachments not
recommended by Dualit may result in
fire, electric shock or injury to persons
A short power-supply cord is to be
provided to reduce risks resulting from
becoming entangled in or tripping over
a longer cord
Longer extension cords may be used if
care is exercised in their use
If a long extension cord is used,
1. The marked electrical rating of the
extension cord should be at least
as great as the electrical rating
of the appliance,
2. The appliance is of the grounded
type, the extension cord should be
a grounding-type 3-wire cord, and
3. The longer cord should be arranged
so that it will not drape over the
counter top or table top where it can
be pulled on by children or tripped
over
Do not operate any appliance with a
damaged lead or plug, or after the
appliance malfunctions or has been
damaged in any manner.
If the mains lead is damaged, it must be
replaced by a special cord set available
from Dualit’s Customer Helpline on
+44 (0)1293 652 500
SAVE THESE
INSTRUCTIONS
Remove all packaging from the kettle and its
power base. Before using the kettle for the
first time, or if it has been out of use for a
long time, fill to the ‘max’ mark and boil, then
discard the boiled water and rinse the kettle
out with fresh cold water.
Connecting to the mains supply
Check that the voltage marked on the
appliance corresponds with the supply
voltage
NOTE: any plug cut from the
power supply cord should be
disposed of immediately.
Inserting any cut off plug into a
13A socket-outlet is hazardous
3
Never use the plug without the fuse
cover fitted. Ensure replacement fuse is
the same current value as the original.
Replacement fuses are available and
should be ASTA approved to BS 1362
NOTE: when you lift the kettle from
the base, you will see drops of
moisture on the surface of the power
base. This is the steam used to switch
the kettle off automatically, which then
condenses and escapes through vents
in the underside of the kettle.
This is perfectly normal, and should not
be cause for alarm or returning the
kettle
SAFETY PRECAUTIONS
READ ALL
INSTRUCTIONS
KEEP THESE INSTRUCTIONS FOR
FUTURE REFERENCE
To be protected against electrical
hazards, do not immerse the mains
lead, plug, power base or kettle in
water or any other liquid
Do not use in bathroom or outdoors
Use handles or knobs – do not touch
hot surfaces
Scalding may occur if the lid is opened
during the brewing cycle
Take care when pouring – pour slowly
and do not over-tilt the kettle
Water will remain hot for a
considerable time after boiling and can
present a scald hazard. Keep the
kettle, power base and the mains lead
away from the edge of worktops and
out of the reach of children
Do not leave appliance unattended
when in use - this is an attended
appliance
Do not operate the kettle on an
inclined plane
Do not move the kettle while it is
switched on
Remove the kettle from its power base
_ before filling or pouring
Allow the kettle to cool down
completely before cleaning and storing
CAUTION: to prevent damage to
the appliance, do not use alkaline
cleaning agents. When cleaning,
use a soft cloth and a mild
detergent
This appliance is not intended for use
by young children or infirm persons
unless they are supervised
• Children should be supervised to
ensure that they do not play with the
appliance
Unplug the power base from the wall
socket when not in use, or before
moving and cleaning
Ensure that the lid is fully closed before
switching the kettle on, otherwise it may
not properly switch off
Ensure that the kettle is correctly
positioned on the power base before
switching on
Do not fill above the bottom of the
‘max’ mark on the water level indicator
Do not place the kettle, power base or
mains lead on or near any hot surface,
hot hob or gas burner
Do not use the kettle for any purpose
other than heating water
Do not operate the kettle unless
the water filter is correctly in
position
Do not operate the kettle unless it
contains at least 250ml of water and
the floor of the kettle is covered
IMPORTANT -
BEFORE USING
4
IB-JKT-C_Layout 1 23/09/2011 10:07 Page 4

Related product manuals