21
Error
Cause
Power Switch
Solution
Turn on the power.
properly, contact local dealer to replace
Check if the discharge terminal
misaligned to the connecting terminal.
plug for looseness, if so, change or
reconnect it and try again.
Cables & wires
Internal loose of cables & wires could
also be the cause. Contact your local
Bike runs sluggish
Poor riding condition
The maxmum load is 35KG, reduce the
load.
For safety reasons, the motor controller
will reduce or stop if the temperature of
let the motor cools down.
Low pressure
Inflate the tire and check the pressure
with tire gauge.
Brake pad
cause high resistance to entire system.
brake system.
Bike runs but stop unintentionally
Brake sensor
If the scooter runs but stop
faulty cables & wires. Contact your
soon as possiable.
Faulty brake sensor can cause scooter to
stop unintentionally. Check and brush
sure brake cable smoothly rebound to its
as possible.
Cables & wires
Pull the brake but the motor is still
running
Brake sensor
Faulty brake sensor, switch OFF the
scooter immediately. Stop using the
scooter and contact your local dealer.
Do not use it againbefore the problems
To Next Page
Loading...
