19
CAUTION
the accelerator is activated once the forward speed exceeds 3 km/h. For safety reasons, the item is initially
• When riding the item, tilt the body in the riding direction during a turn and slowly turn the handlebars.
• To stop the item, release the accelerator, pull the brake lever.
• Prior to each use, check brakes and any wear, check tyre pressure (see side of tyre for recommended value), wheel wear,
Brake lever adjustment
Brake levers
Refer to point A (see photo) to adjust the position of the brake lever, if
necessary.
Regolazione dei freni
Adjusting the brake calliper
If the brake is too tight or too loose, use the hex
wrench to loosen the nut (A), then adjust the brake
and then, retighten the nut (A). If the wire is too loose
be necessary to adjust the (fixed) brake pad by means
away (see picture).
Check the correct alignment between the brake caliper
and the disc. Use screws C and D to adjust the position
/ alignment on the disc, if necessary.
the footrest and fasten it.
Closing
closing mechanism: press the red hook and pull the lever
outwards (see picture), move the handlebar stem inwards
and make sure it is locked.
Opening: Unlock the handlebar stem from the mudguard:
stem all the way and lock it in place by pushing the lever
inwards.Switch on the electric scooter.
Always carry the scooter with one or both hands holding the
handlebar stem.
handlebar rod with your hand, then pull the lever and
align the handlebar hook with the hook located on the rear
mudguard.
hands.
CAUTION
dropped, the item may cause severe injury and damage.
7.
To Next Page
Loading...
