ducduc alex CRIB - Page 3

Lay END PANEL
A
on � floor with rail-connector-holes facing up.
1
2
B
Align SIDE RAIL to END PANEL so that the rail-connector-holes
on SIDE RAIL line up with the rail-connector-holes on END PANEL .
Make sure the four mattress-support-holes face the bottom and
inside of END PANEL . Refer to picture for correct orientation.
Label on bottom of END PANEL and SIDE RAIL that reads
“Bottom” should be facing the bottom of the CRIB.
A
B
A
A
A
A
B
mattress-support-holes
rail-connector-holes
rail-connector-holes
rail-connector-holes
A
assembly
B