Duke HSHU 13 SERIES - User Manual

28 pages

Save Page as PDF

To Next Page

To Next Page

Loading...

U.S. Patent 6175099, 6262394

Other U.S. and Foreign

Patents Pending

Installation and

Operation Manual

MODEL

HSHU 13 SERIES

HSHU 22 SERIES

HSHU 23 SERIES

HSHU2 22 SERIES

HSHU

(HEAT SINK

HOLDING UNIT)

P/N 158270

REV L 10/30/2017

This manual is Copyright © 2017 Duke Manufacturing Co. All rights reserved.

Reproduction without written permission is prohibited. Duke is a registered

trademark of the Duke Manufacturing Co.

Duke Manufacturing Co.

2305 N. Broadway

St. Louis, MO 63102

Phone: 314-231-1130

Toll Free: 1-800-735-3853

Fax: 314-231-5074

www.dukemfg.com

CAUTION:

Please read this manual completely before attempting

to install, operate or service this equipment

Table of Contents

Questions and Answers

E
Eric HayesAug 11, 2025
What to do if Duke HSHU 13 show over-temperature fault?
- G
  gbarkerAug 11, 2025
  If the Duke Control Systems display an over-temperature fault, it means the shelf temperature has exceeded the factory preset for thirty minutes. You should not use the unit until a qualified service technician has corrected the issue.
C
cheryl71Aug 20, 2025
Why Duke HSHU 13 show under-temperature fault?
- K
  Katie HamiltonAug 20, 2025
  An under-temperature fault in Duke Control Systems indicates that the shelf temperature has been below the factory preset for over thirty minutes continuously. This can happen if the heating element circuit opens or the RTD Feedback signal is faulty. You should not use the unit until a qualified service technician addresses the problem.
T
taramorganAug 31, 2025
What to do if Duke HSHU 13 display a sensor fault?
- J
  Jamie MackAug 31, 2025
  If your Duke Control Systems unit is showing a sensor fault, you should discontinue operation and contact a qualified service technician.

Duke HSHU 13 SERIES Specifications

General

Brand	Duke
Model	HSHU 13 SERIES
Category	Control Systems
Language	English