KIT CONTENT
Please note that this is the minimum kit content. For wider width
blinds, there will be additional brackets, screws and wall plugs.
TOOLS REQUIRED
Take care when using the tools. Wear gloves and eye protection.
CARE ADVICE
Wipe clean only
Roman Blind Fitting Guide
Thank you for purchasing this product. Please read the instructions and warning
carefully before use to ensure safe and satisfactory operation of this product.
Keep these instructions for future reference.
The safety clips or cleats must be positioned high enough to be out of reach of
small children. In all cases the distance from the floor to the bottom of the chord
and cleats must be at least 1.5 m. The head rail shall not be installed less than 1.5m from the floor.
All safety clips for blinds need to be fixed to a solid surface using a screw
and fixing suitable for the wall or surface material. These items should not be glued.
Small Parts can present a choking hazard if accidently swallowed.
Keep small parts away from young children.
We do not recommend that roman blinds are cut to size.
Ensure that all wall plugs and screws provided are suitable for your type of wall/window.
If in doubt, consult a professional.
Blind with fitted head rail x1
Pencil
Screws x 6
Ruler/tape measure
Drill
Wall plugs x 6
Fixing Brackets x 2
Safety Device
(Cleat)
Young children can be strangled by loops in pull cords,
chains, tapes and inner cords that operate the product.
To avoid strangulation and entanglement, keep cords out of
the reach of young children.
Cords may become wrapped around a child’s neck. Move
beds, cots and furniture away from window covering cords.
Do not tie cords together. Make sure cords do not twist and
create a loop.
WARNING
OPERATING THE BLIND
Raise: Pull down on the cord to raise
the blind to your desired height.
Unlock: Unwind the cord
from the cleat and pull
the cord to the left.
Lower: Once unlocked, the blind
should lower freely.
Lock: Pull the cord to
the right and secure
the cord onto the
cleat.
To Next Page
Need help?
General