Need help?Do you have a question about the DUO-FAST DF225C and is the answer not in the manual?
General| Power Source | Pneumatic |
|---|---|
| Nail Size | 0.113" - 0.131" |
| Fastener Range | 2 inches to 3-1/4 inches |
| Fastener Length | 2 inches to 3-1/4 inches |
| Shank Diameter | 0.113" - 0.131" |
Mandates wearing ANSI Z87.1 compliant eye and hearing protection during operation.
Emphasizes using the tool only for its intended design purpose and not as a hammer.
Instructs to always check the magazine for fasteners, never assuming the tool is empty.
Prohibits disabling or locking the trigger, which can cause accidental firing.
Requires disconnecting the air line and ensuring trigger/contact element are not depressed during loading.
Stipulates that the tool must be in contact with the workpiece to operate.
Warns against tampering with or removing the work contacting element, essential for safety.
Emphasizes disconnecting the tool from the air line when not in use or unattended.
Instructs to carry the tool only by its handle to prevent accidental firing.
Requires disconnecting air and removing fasteners before performing repairs or clearing jams.
Mandates using male pneumatic fittings that vent air pressure when disconnected.
Warns against operating the tool above the maximum recommended air pressure.
Stresses using only genuine Duo-Fast parts and fasteners to prevent dangerous situations.
Critical safety warning: Air pressure must never exceed 120 psi.
Step-by-step instructions for loading nails into the tool's magazine.
Emphasizes using only Duo-Fast specified fasteners to prevent damage or injury.
Instructions on how to drive fasteners using different trigger modes.
Guidance on determining the correct compressor size using an air consumption chart and formula.
Importance of proper lubrication, recommended lubricants, and daily/periodic lubrication methods.
Troubleshooting steps when fasteners do not drive fully into the workpiece.
Diagnosing and resolving intermittent skipping or failure to drive fasteners.
To Next Page