Need help?Do you have a question about the Duoyi DY219 and is the answer not in the manual?
Set the tested voltage according to the battery type. Select 12V or 24V mode before proceeding to other tests.
Offers quick and accurate test methods. Accurate test uses CCA directly from the battery label for precise results.
Tests the vehicle's starting system by measuring battery voltage during engine crank. Compares to standard values for good/bad assessment.
Tests the battery's performance under maximum load by simulating engine start and running conditions. Checks voltage under load.
Evaluates the vehicle's charging system by measuring battery voltage while the engine is running at specified RPMs. Checks voltage regulator.
Explains the tester uses AC conductivity test principle, measuring AC current signal to voltage ratio to assess battery health.
Negative current installation affects results. Remove negative currency prior to checking for accurate data. Check connections.
Predicting exact battery life is impossible due to complex internal resistance. Sudden increase may indicate imminent failure.
Tested CCA values are generally 10-15% higher than standard for new batteries and approach standard as battery ages.
This tester uses AC signal. Traditional load test uses high DC current for a short period to measure voltage drop.
Provides a reference table for JIS battery standards, including CCA, MF, and CMF values, for comparison with test results.
Explains internal resistance varies due to chemical features, affecting discharge ability. Measured in milliohms.
Capacity cannot be estimated by intuition. Hydrometer and specific gravity are used to check battery water and acid proportion.
Defines common battery standards and abbreviations like RC (Reserve Capacity), CCA (Cold Cranking Ampere), CA, and AH (Ampere Hour).
General| DC Current | 200μA/2mA/20mA/200mA/10A |
|---|---|
| Resistance | 200Ω/2kΩ/20kΩ/200kΩ/2MΩ/20MΩ |
| Diode Test | Yes |
| Continuity Buzzer | Yes |
| Transistor Test | Yes |
| Power Supply | 9V Battery |
| Fuse Protection | Yes |
| DC Voltage | 200mV/2V/20V/200V |
| AC Voltage | 200V |
| Display | LCD |
To Next Page