6
General information
The equipment
Unintended use of the equipment
Glunz & Jensen does not take any responsibility for any damage or accidents caused by unintended use of
the equipment.
It is absolutely prohibited to make any modifications, electrical or mechanical, of the equipment. If
however this prohibition is disregarded, Glunz & Jensen's warranty will no longer apply.
Intended use of the equipment
Development and/or processing of flexographic plates as specified in Technical Specifications in the
Service Manual.
This equipment is a part of a full range dedicated for the treatment of flexographic printing plates. This
range includes exposure, processor, dryer and light finisher.
Installation
WARNING: The equipment must be installed in restricted access locations only.
• Never install the equipment in explosive environments.
• It is the responsibility of the owner and operator(s) of the equipment that the installation is made in
accordance with local regulations, and by engineers authorized to carry out electrical, compressed air
and HVAC installations.
• The manufacturer cannot be held responsible for any damage caused by incorrect installation of the
equipment.
• Installation, service and repair must be performed only by service technicians who are trained in
servicing the equipment. The installation procedure is described in the chapter 'Installation' in the
Service Manual.
Service assistance
If help is needed to correct any problem with the equipment, please contact your local supplier.
User's Guide|Cyrel® 2000 ECLF July, 2019
To Next Page