Daily use
9
CAUTION: Make sure that the cooler tank is filled with proper cooling liquid before turning the
machine on. See Service manual for more details.
NOTE: Make sure the room temperature is between 17°C (63°F) and 28°C (82°F) and relative
humidity between 20 and 80.
NOTE: Before turning the equipment on make sure that the working area around the equipment is
clean and free for easy movement. All the covers must to be closed.
NOTE: Check all the required supplies and connections, as power cable and all the hoses are
connected properly. Check if there are any leaks of liquid.
NOTE: Check that the emergency stop button is released. If it is not, release it by turning it
clockwise.
• Turn the main switch (1) of the machine, which is located on the electrical box door on the left of the
machine.
• Verify that emergency stop button (2) is released (front panel). If not, release it by turning it clockwise.
• Switch the machine on by pressing the ON/OFF button (3), which is located on the electrical box door
on the left of the machine.
• After a couple of second of display initialization the main screen is displayed.
NOTE: If the machine has been switched off during at least one process on going, the following
screen appears at the switch ON of the unit asking to continue the cycles which have been
interrupted (restart exactly at the point it has been stopped) or to reset all on going cycles.
July, 2019 User's Guide|Cyrel® 2000 ECLF
To Next Page