PROBLEM POSSIBLE CAUSE REMEDY
On the display appears the writing FAIL.
Switches and buttons are blocked
(do not react to the command).
A. The microprocessor of the system execut
-
ed a non valid operation and interrupted
the scanning of the program.
A. Disconnect the plug from the electric
socket, wait a minute, then connect
it again.
Noise inside the boiler. A. The boiler getting cold, aer about 6-7
hours creates an internal depression
which, at each ignition, provoke some
vibrations.
A. Wait until the pressure stabilizes (about
2-3 minutes), the noise will disappear.
Steam pressure is dropping when in use. A. The steam pressure is set to maximum
for too long.
A. Use lower pressure setting. (14 AND 15)
To Next Page
Loading...
