Dupray TOSCA - How to Use Your Steam Cleaner; Step-by-Step Operation

12 13 34
11
21
15
14
16
10
20
22
23
24
25 26 27
28
31
29
30
33
19
32
17
18
35
36
ACCESSORIES
10. STEAM HOSE
11. STEAM RELEASE TRIGGER
12. STEAM PRESSURE
CONTROL BUTTON
13. STEAM PRESSURE
INDICATORS
14. ACCESSORY
LOCK / RELEASE
15. STEAM HOSE
CONNECTOR
16. HOSE LOCKING PIN
17. EXTENSION TUBES
18. EXTENSION TUBES
LOCKING PIN
19. RECTANGULAR TOOL
20. CLOTH HOLDING CLIPS
21. TRIANGULAR TOOL
22. WINDOW TOOL
23. LANCE
24. LARGE NYLON BRUSH
25. SMALL NYLON BRUSH
26. SMALL BRASS BRUSH
27. SMALL STAINLESS
STEEL BRUSH
28. STEAM SCRAPPER
29. PLUNGER TOOL
30. STEEL WOOL
31. REFILLING BOTTLE
32. MICROFIBER CLOTH
33. MICROFIBER PAD
34. LOW WATER INDICATOR
35. TRIANGULAR TOOL
MICROFIBER BONNET
36. RECTANGULAR TOOL
MICROFIBER BONNET
HOW TO USE YOUR STEAM CLEANER
1. Remove the boiler cap (1) and fill the tank with up to 0.5 gallon / 1.8 litres of regular tap water. Securely replace
the boiler cap. The refilling bottle is 30 oz / 900 ml.
2. Unravel completely the electrical cord (9). Connect the electrical cord to a 15 or 20 amp 110V/120V power outlet.
(make sure the circuit is not already used by another high wattage appliance).
3. Turn ON the main power switch (2A), press the power button (2), and then press the boiler activation button (3). The SteamReady™
indicator (5) will light up when the steam cleaner is ready to use, aer approximately 7-10 minutes of heat up time. This light is only
ON when the unit is at maximum operating pressure. While in use, the light will turn OFF automatically, indicating that the boiler
is producing steam.
4. Connect the steam hose (10) by inserting the steam hose connector (15) in the steam hose connection outlet (7) and press firmly.
5. Select the desired steam pressure (on the hose handle) between minimum, medium and maximum (12).
6. Connect the steam hose (10) to the accessory that you want to use.
7. To release steam, press the steam release trigger (11) on the hose handle.
8. When you are done using your steam cleaner, turn the unit OFF by pressing on the power button (2).
Turn OFF the main power switch (2A) and unplug the machine. Your steam cleaner is now ready for storage aer cool down.
WARNING: Always turn OFF the main power switch (2A) when leaving the machine unattended.
9. It is safe to leave water in the boiler when the steam cleaner is not in use. If it is for an extended period of time (months),
then it is best to flush out the remaining water. To do so, follow the water removal instructions as outlined in the maintenance
of the boiler section.
8
en