Duracraft DC1800 User Manual (English)

Questions and Answers:

W
William PittmanAug 1, 2025
Why won't my Duracraft DC1800 Pressure Washer motor start or why does it stop?
- R
  Rebecca ReynoldsAug 1, 2025
  The Duracraft Pressure Washer motor might not start or may stop due to several reasons: the GFCI may have tripped (turn off the unit and firmly press the GFCI reset button after connecting to the electrical supply), the circuit breaker may have tripped or a fuse blown (disconnect other loads on the same circuit and reset the breaker or replace the fuse), the plug may be loose (reconnect it), or the pressure washer circuit breaker may have tripped (allow the unit to cool before restarting).
R
Robert Richardson MDAug 6, 2025
What to do if the circuit breaker trips or fuse blows in my Duracraft Pressure Washer?
- D
  Danny LeAug 6, 2025
  If the circuit breaker trips or a fuse blows when using your Duracraft Pressure Washer, it could be due to a circuit overload (ensure the circuit is rated 15 amps or greater and disconnect other loads), an incorrect extension cord (use the recommended cord from the manual), a partially blocked nozzle (clean the nozzles as instructed in Section 5.2), or excessive pressure (reduce the pressure using the adjustment knob).
A
Andrea WardAug 11, 2025
How to fix a Duracraft DC1800 Pressure Washer when the motor runs but the pump lacks pressure?
- B
  Brian SimmonsAug 11, 2025
  If your Duracraft Pressure Washer motor runs, but the pump isn't building maximum or has irregular pressure, consider these possibilities: ensure the faucet is open, check if the unit has been stored in freezing temperatures and thaw it completely, inspect the water inlet screen for clogs and clean it, bleed air from the pump by running the pressure washer with the gun open and wand removed until a steady stream appears, or ensure the adjustable pressure knob is set to maximum.
H
hickscharlesAug 16, 2025
Why is my Duracraft DC1800 Pressure Washer not intaking chemicals?
- D
  David GonzalesAug 16, 2025
  If your Duracraft Pressure Washer isn't intaking chemicals, check if the injection tube is securely inserted, replace the tubing if it's cracked, switch the nozzle to low pressure, clean the nozzle if blocked, clean the injection tube strainer if clogged, or dissolve dried chemicals by running warm water through the injection tube.
C
Charles GutierrezAug 21, 2025
Why is water or oil leaking from the bottom of my Duracraft DC1800 Pressure Washer pump?
- A
  April PotterAug 21, 2025
  A small amount of leakage from the bottom of the Duracraft Pressure Washer pump is normal. If excessive leaking occurs call Powerwasher Help Line Customer Service Department.
J
jenny95Aug 26, 2025
How do I fix a Duracraft Pressure Washer trigger that won't move?
- C
  Christopher SchneiderAug 27, 2025
  If the trigger on your Duracraft Pressure Washer won't move, the gun safety lock may be engaged. Try releasing the safety lock.