EasyManuals Logo

DuraMax LML User Manual

DuraMax LML
134 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #19 background imageLoading...
Page #19 background image
Black plate (9,1)
DURAMAX Diesel Engine (LML/LGH) - 2011
Instruments and Controls 5-9
The vehicle may not pass
inspection if:
.
the check engine light is on with
the engine running, or if the light
does not come on when the
ignition is turned to ON/RUN
while the engine is off.
.
the critical emission control
systems have not been
completely diagnosed by the
system. This can happen if the
battery has recently been
replaced or if the battery has
run down. The diagnostic
system evaluates critical
emission control systems during
normal driving. This can take
several days of routine driving.
If this has been done and the
vehicle still does not pass the
inspection , your dealer can
prepare the vehicle for
inspection.
Wait-to-Start Light
The wait to start light shows that the
engine is functioning properly and
indicates when the engine can be
started.
The fast warm-up glow plug system
makes the wait to start light stay on
for a shorter amount of time than
most diesel engines.
For more information, see Starting
the Diesel Engine on page 91.
Diesel Exhaust Fluid
(DEF) Warning Light
This light, a Driver Information
Center (DIC) Message, and a chime
come on when there is an issue with
the Diesel Exhaust Fluid.
See Diesel Exhaust Fluid Messages
on page 512 for information on the
specific message displaying with the
light.
If the DEF fluid level has not been
corrected, the light will continue to
flash when the vehicle is started or
after a fuel refill. The vehicle's
speed may also be limited.
Also see Diesel Exhaust Fluid on
page 912 for more information.
All manuals and user guides at all-guides.com

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the DuraMax LML and is the answer not in the manual?

DuraMax LML Specifications

General IconGeneral
Block MaterialCast Iron
Head MaterialAluminum
Displacement6.6L
Horsepower397 hp @ 3000 rpm
Torque765 lb-ft @ 1600 rpm
Fuel SystemHigh-pressure common rail direct injection
TurbochargerVariable geometry turbocharger
ValvetrainOverhead Valve (OHV)
Emission ControlDiesel particulate filter (DPF)
Engine Oil Capacity10 quarts
Bore x Stroke103 mm x 99 mm (4.06 in x 3.90 in)