Driving and Operating 9-49
The following conditions must be
met before attempting to remote
start the engine:
.
The vehicle must be configured
for stationary PTO operation by
a qualified dealer.
.
The parking brake must be set.
.
The transmission shift lever must
be in P (Park).
.
The vehicle hood must be
closed.
Once the above conditions are met,
continue the remote start by doing
the following steps using the remote
PTO controls:
1. Press and release the remote
start arming switch.
2. Within five seconds of releasing
the remote start arming switch,
press and hold the engine start
switch for about two seconds
(horn will sound) until the engine
starts.
3. Release the remote engine start
switch.
To enable normal PTO operation
after remotely starting the vehicle:
1. Press and release the remote
start arming switch.
2. Within five seconds of releasing
the remote start arming switch,
the PTO remove enable switch
must be moved from OFF to ON.
3. The PTO system will raise
engine rpm to standby speed
and engage the PTO load.
Press the remote PTO −/SET or
+/RES switch to elevate PTO to
the desired engine operating
speed.
Remote Engine Shutdown
Control
The vehicle’s PTO system allows for
remote engine shutdown while
operating in the stationary PTO
mode. This feature has the following
functions:
.
Engine shutdown using the
operator remote switch:
The vehicle wiring system
provides remote engine
shutdown switch connections,
which is accessed through the
PTO upfitter connector.
.
Timed auto-engine shutdown:
The timed auto-engine
shutdown feature provides the
means to shut down the engine
automatically after a predefined
time. PTO must be operational
for this function to be active.
To Next Page
Loading...
Need help?
General