Driving and Operating 9-51
Factory Preset Parameters
The following table lists the factory preset parameters. These may be altered by the service technician to configure
the various PTO features.
Programmable
Parameters
Factory Setting Minimum Value Maximum Value
PTO In-cab Control ENABLED DISABLED ENABLED
PTO Remote Control DISABLED DISABLED ENABLED
Type of Set Switch
Operation
MOMENTARY MOMENTARY LATCHING
Press ON then go to
Set 1 Speed
DISABLED DISABLED ENABLED
Remote Engine Start DISABLED DISABLED ENABLED
Remote Engine Shutdown DISABLED DISABLED ENABLED
Load feedback DISABLED DISABLED ENABLED
Engage Relay DISABLED DISABLED ENABLED
Keep Relay engage
during braking
DISABLED DISABLED ENABLED
To Next Page
Loading...