Duratool ZD-915 - Specifications; Operation; The Display and Temperature Setting

2. Specifications
Code
Voltage
Note
89-8511 110~130V
89-8512 220~240V
89-8513 110~130V ESD
89-8514 220~240V ESD
Spare desoldering gun:
Model
Voltage
Power
NOTE
ZD-552A
24V
80W
6 pins, no sleep function
Technical data:
Station Desoldering gun
Input voltage
110-130VAC
220-240VAC
Voltage
24V
Power 140W Power 80W
Heat up rating 200W
Main fuse
3.15A
Temperature
160℃- 480℃
Vacuum
pressure
600mm Hg Heating
element
PTC ceramic heater
3. Operation
3.1 Place the desoldering gun in the holder separately. Then connect the plug to the
receptacle on the station and turn clockwise to tighten the plug nut. Check that the
power supply is corresponding to the specification on the type plate and the power
switch is at the “OFF” position. Connect the control unit to the power supply and
switch on the power. Then a self-test is carried out in which all display elements are
switched on briefly. The electronic system then switches on automatically to the set
temperature and displays this value.
3.2 The display and temperature setting
The digital display: