Need help?Do you have a question about the DuraVent PolyPro Series and is the answer not in the manual?
Importance of maintaining required clearances for fire prevention.
Risks from improper installation, joint separation, or pipe breakage.
ULC S636 listing and suitability for Category II & IV appliances.
Checking permits and following general installation guidelines.
Table detailing required clearances for vent pipe orientation and temperature.
Requirements for condensate drain setup and equivalent length calculations.
Guidelines for enclosing vents and firestop installation at penetrations.
Table specifying penetration sizing for various vent diameters and terminations.
Connecting Single-Wall pipes and transitioning to other vent systems.
Connecting to appliance outlets and preparing pipes for installation.
Instructions for horizontal and vertical terminations of single-wall vents.
Guidelines for supporting vents and installing multiple vents in conduit.
Securing concentric PolyPro vent joints using self-tapping screws.
Connecting to appliance outlets and general installation of concentric vents.
Instructions for horizontal and vertical terminations of concentric vents.
Annual checks, inspection points, and procedures for maintaining the venting system.
Details on the ten-year warranty, coverage, limitations, and service claims.
To Next Page
General