en
Mounting instructions
Please read pre-installation information sheets prior to
the installation. These are available to download on the
Internet at www.pro.duravit.com.
Mounting instructions
3
Mounting the cable-driven waste and overflow
The connecting hose #790166 is recommended for
mounting a cable-driven waste and overflow with a
bath spout or base inlet.
18
Providing for an inspection hatch
• Area: Cable-driven waste and overflow
• Dimensions of the inspection hatch
for the cable-driven waste: min. 20 x 20 cm
21
Using silicone without acetic acid
> Use alkoxy-based silicone.
23
Closing the inspection hatch
• sealed to avoid spray water
• only to be opened with a tool
Mounting instructions information
These mounting instructions come as part of the Duravit
bathtub and should be read carefully prior to installation.
Explanation of the key words and symbols
NOTICE
Is used to address practices not related
to physical injury.
Link to the mounting instructions in this section
Inspection (e.g. for scratches)
Indication of the length of time (e.g. 10 minutes)
Inspect to check for leaks and leak-tightness
Target readership and qualifications
The bathtub must only be installed by trained plumbing
engineers.
NOTICE
Risk of product and/or property
damage!
> Observe the local installation regulations and any
country-specific standards at all times.
Important information
BA_M_DuraSquare_built-in/17.02.1 5
To Next Page
Loading...
