Duronic BFH20 - Page 4

6 7
Safety Instructions (Continued)
Technical Specications
• Do not touch the hot surfaces.
• Always ensure that your hands are dry before operating or adjusting any switch on the
product or touching the plug and socket.
• Do not leave this appliance unattended when it is in use.
• The most common cause of overheating is deposits of dust or uff in the appliance.
Ensure these deposits are removed regularly by disconnecting the appliance and then
vacuum cleaning the air vents and grills.
• Do not place the heater on a carpet or put the cable under a carpet.
• Place the cable in such a way that it is not in any high trafc area to avoid it being
tripped over or stood on.
• Do not put the heater away until it has cooled down completely. Store the heater in
cool dry location when not in use.
• This product is only suitable for well insulated spaces or occasional use.
• Some parts of this product can become very hot and cause burns.
Particular attention has to be given where children and vulnerable people are
present.
If the machine is operated with a defective or damaged mains cable,
there is a potential danger of fatal electric shock.
Never use a machine which is damaged or has a damaged mains cable.
Installation
As a general guideline, please see the below diagrams which
illustrate how and where to install the heater safely.
In order to avoid a hazard for very young children, this heater should be
installed so that the lowest part of it is 120cm above the oor.
Model BFH20
Rated Voltage 220 - 240V
Rated Frequency 50-60Hz
Rated Power 2000W
Protective Class II
IP Code IP24
This heater should be installed in accordance
with the British IET BS 7671 Regulations.
Step 1 Step 2
Step 4 Step 5
Step 3